bulk density

Snakeweed (Gutierrezia sarothrae) Habitat Soils Data from the Sevilleta National Wildlife Refuge, New Mexico (1984)

Abstract: 

In 1984, a research project was initiated on a relatively small disturbance patch just south of Deep Well. This disturbance was thought to be the result of an old praire dog town, probably dating back to when a nearby ranch was active, and a lot of old mammal mounds remained in the disturbed area. One of the things that made the disturbance patch particularily noticeable was the lush growth of snakeweed (Gutierrezia sarothrae) within the patch. This prompted the designation of the disturbance patch as the "snakeweed patch" or "Gutierrezia patch." In addition, there was an obvious increase in bare ground and a shift in vegetation composition across the patch boundary. The dominant vegetation was not consistent around the boundary, with a marked dominance of black grama on the west side of the plot and a blue/black grama mix on the other three sides. To obtain information on the cause and/or effect of this disturbance, a survey of the soil and vegetation was performed.

Core Areas: 

Data set ID: 

150

Additional Project roles: 

103
104
105

Keywords: 

Data sources: 

sev150_snakeweedsoil_03302009

Methods: 

Sample collection - The soil samples were collected using a hammer-driven soil corer. The barrel of the corer was fitted with a plastic sleeve that allowed extraction of the soil core generally intact. TheĀ  soil corer was driven to a depth of 50 cm and soils split ito 10 cm fractions. This data set contains data for only the top 30 cm.

Samples were taken along six 100 m transects. Four of these transects crossed the patch boundary on the four cardinal points. On these four transects the 0m sample was taken starting 50 m outside the boundary, the 50 m sample was taken at the patch boundary and the 100 m sample was taken 50 m into the patch. The other two transects formed a cross near the center of the patch.

Twenty-one cores were collected along each transect, with increased sampling intensity near the boundary. However, this data set contains data from only the 10 m intervals for a total of 11 samples.

Sample processing - Soil samples were kept in a refrigerator prior to analysis. Each sample was weighed and samples were well-mixed before analysis. Samples were sieved through 2mm screens to remove pebbles and roots. A sample of 25 g was added to a preweighed soil can. Samples were dried for 24 hours at 105 degrees C then cooled and then reweighed. This dry/wet moisture correction was used to calibrate weights for other samples. A 1 g sample was taken from the oven-dried samples and ashed at 500 degrees C for 2 hours and re-weighed after cooling. This provided a measure of organic content. A 12 g sample was weighed into a 125 ml plastic bottle and 100 ml of 2 N KCL added before the bottles were well-shaken. After standing for 24 hours, the KCL was decanted and the samples analyzed for NO3-N and NH4-N on a Technicon Autoanalyzer. Another 5 g sample was weighed into a centrifuge tube and extracted repeatedly with pH 7 ammonium acetate. These samples were brought up to 250 ml and analyzed for Ca, Mg and K using atomic absorption. Fifty g samples of soil were mixed and texture determined using the hydrometer method. Samples were mixed 2:1 with 0.001N CaCl2 and pH measured. From the oven-dried samples 1 g samples were digested using sulfuric acid using the Kjeldahl method. Samples were then brought up to 250 ml and analyzed on a Technicon Autoanalyzer for total nitrogen and phosphorous.

Coordinates (NAD27): 

End of

Transect Transect Latitude Longitude

North 0 34 21' 1.2" 106 41' 8.3"W

100 34 20' 57.9"N 106 41' 8.6"W

East 0 34 20' 47.0"N 106 41' 1.6"W

100 34 20' 46.5"N 106 41' 5.4"W

West 0 34 20' 53.7"N 106 41' 16.3"W

100 34 20' 53.7"N 106 41' 12.4"W

GCSA 0 34 20' 49.1"N 106 41' 9.2"W

100 34 20' 45.6"N 106 41' 9.2"W

GCSB 0 34 20' 47.1"N 106 41' 8.9"W

100 34 20' 47.4"N 106 41' 5.1"W

Maintenance: 

12/10/00 (DM) File created.2/10/2009. (DM) Metadata was updated and compiled.

Subscribe to RSS - bulk density